ISO1I811T
Functional Description
3.7
Parallel Interface Mode
The ISO1I811T contains a parallel interface that can be selected by pulling the SEL Pin to logic low state. It can
be directly controlled by the microcontroller output ports. ( Figure 9 , left side). The output pins D7:D0 are in state
“Z” as long as CS=1. Otherwise, new sensor data bits bits are sampled with the falling edge of RD and provided
at pins D7:D0.
The parallel interface can also be switched over to a direct control mode to observe continuously the changes of
the inputs I0H ... I7H by means of the corresponding outputs D7:D0 without additional logic signals. To activate
the parallel direct control mode pin CS and pin RD have to be connected both to ground (permanently as in
Figure 9 , right side or by the microcontroller ports). The Direct Control Mode is entered when at least CS and RD
are held low for t direct ( Table 14 ).
VCC
/CS
/RD
D0
D1
D2
D3
D4
D5
D6
D7
VCC
MCU (e.g. XE166)
or ASIC
VCC
/CS
/RD
D0
D1
D2
D3
D4
D5
D6
D7
VCC
MCU (e.g. XE166)
or ASIC
ISO1I811T
SEL
ISO1I811T
SEL
parallel _interface1.vsd
Figure 9
Parallel Bus Configuration for μC-Control-Mode (left) or Direct Control Mode (right)
The timing requirements for the parallel interface are shown in Figure 10 and in Table 14 .
/CS
t CSD
/RD
t CSS
t RDlow
t valid
t RD
t float
t direct
t valid
D7:D0
scan event
t scan
data
t scan
data
~8 scan cycles
data
data
data
direct control mode
Figure 10
Parallel Bus Timing
Data Sheet
15
Revision 2.0, 2012-06-14
相关PDF资料
ISO7221AQDRQ1 IC DGTL ISOLATOR 1MBPS DL 8SOIC
ISOBAR4 ULTRA SURGE SUPPRSSR 4OUT 6'CORD W/LED
ISOBAR6 ULTRA SURGE SUPPRSSR 6OUT 6'CORD W/LED
ISOBAR6DBS SURGE SUPP DSS 6OUT 6'CORD W/LED
ISOBAR6ULTRAHG SURGE SUPP 6OUT 15'CORD HOSP GRD
ISOBAR6 SURGE SUPPRSSR 6OUT 6'CORD
ISOBAR8 ULTRA SURGE SUPPR 8OUT 12'CORD W/LED
ISOBLOK2-0 SURGE SUPP ISOBAR 2 OUT/DIRECT
相关代理商/技术参数
ISO1I811TXUMA1 制造商:Infineon Technologies AG 功能描述:ISOFACE - Tape and Reel 制造商:Infineon Technologies AG 功能描述:IC DGTL ISO 8CH PAR SER 48TSSOP
ISO1I811TXUMA1/SAMPLE 制造商:Infineon Technologies AG 功能描述:ISOFACE - Tape and Reel
ISO1I813T 功能描述:ISOLATOR DGTL 500VAC 8CH 48TSSOP RoHS:是 类别:隔离器 >> 数字隔离器 系列:ISOFACE™ 标准包装:66 系列:iCoupler® 输入 - 1 侧/2 侧:2/2 通道数:4 电源电压:3.3V,5V 电压 - 隔离:2500Vrms 数据速率:25Mbps 传输延迟:60ns 输出类型:逻辑 封装/外壳:20-SSOP(0.209",5.30mm 宽) 供应商设备封装:20-SSOP 包装:管件 工作温度:-40°C ~ 105°C
ISO1I813TXUMA1 制造商:Infineon Technologies AG 功能描述:Isolated 8 Channel Digital Input 48-Pin TSSOP 制造商:Infineon Technologies AG 功能描述:ISOFACE - Tape and Reel 制造商:Infineon Technologies AG 功能描述:ISOLATOR DGTL 500VAC 8CH 48TSSOP
ISO2 制造商:未知厂家 制造商全称:未知厂家 功能描述:ASIC
ISO212 制造商:BB 制造商全称:BB 功能描述:Low Cost, Two-Port Isolated, 1500Vrms ISOLATION AMPLIFIER
ISO212JP 制造商: 功能描述: 制造商:undefined 功能描述:
ISO212JP-15 制造商:BB 制造商全称:BB 功能描述:Low Cost, Two-Port Isolated, 1500Vrms ISOLATION AMPLIFIER